![]() ![]() I just set it at that, and thought "What the heck, I've tried about everything else". So just curious has anybody else come across this issue? Very odd that there would be so many hard faults when I have plenty of RAM left in the standby and free status. I restarted my computer, and bam, the choppiness is gone, and the 'hard faults/sec' are near nothing (occasionally a small one pops up, but it's in the 2-5 range). I have pretty much always left it as "Windows managed", however I decided to manually set the minimum and maximum value to the same size (based on recommended Windows page file size). I decided to take a look at my Windows page file. I found this to be odd since I am only using 35% of my installed memory. It never went up or down, and was a steady line of 100. I went to my resource monitor, and I notice on the memory tab, it was showing a non-stop stream of 'hard faults/sec' of 100. Then today I was playing around in my computer when the choppiness returned. ![]() I initially thought maybe it was some other 2.4Ghz interference, but that wasn't it. So I replaced my mouse, reset my computer, etc., yet occasionally this would return. If I was playing a game, I'd have to stop because it was so unbearable. And then occasionally when sitting at my desktop, playing a game, or really doing anything on my PC, my USB mouse would become choppy, and I couldn't really do anything smoothly. If many processes are causing page faults, a condition known as thrashing can occur.So, for the past 6 months or so, my PC would be fine 99.9% of the time. The process requesting the page must wait while the operating system makes room for the requested page in memory and reads it from disk or relocates it, which may cause a significant delay for the faulting process. If this number exceeds the configured threshold, the agent will issue an alert.Ī page fault occurs whenever the operating system tries to access a virtual memory page that is not currently in memory or is in the incorrect place in memory. The Directory Analyzer agent constantly monitors the Page Faults/sec performance counter on the domain controller. If possible, stop the program and run it on a different computer. If one process is using all of the CPU for an extended period of time, it may be due to a bug in the software, or it may be that the program just requires too much CPU. If there are several processes getting more than 10% of the CPU, then the problem is most likely due to running too many programs on the server. Use a utility like Task Manager to inspect the CPU usage of all processes on the system. Resolutionįirst, try to determine if the increased CPU load is due to a particular program, or if it is due to running too many programs. Active Directory can also require a lot of CPU resources when it processes complex, non-indexed directory searches. For instance, Active Directory ® itself requires substantial CPU resources when it is processing inherited Access Control Lists (ACLs). It is also possible that the CPU load has increased due to some pathological condition in a particular application. Increased CPU load is a result of running too many applications on the server, or running applications that require too much CPU time. If the value of the performance counter goes above the configured threshold for a period exceeding the configured duration, the agent will set this alert condition. The Directory Analyzer agent monitors the Processor\% Processor Time performance counter on the domain controller. ![]() Required permissions: When monitored locally and remotely, only domain user privilege is required and the user must be a part of the Performance Logs user group. ![]() Security Accounts Manager Service is not running Missing SRV DNS record for either the primary or secondary DNS server Invalid secondary DNS domain controller address Invalid primary DNS domain controller address Intersite Messaging Service is not running
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |